The correct operation method of woodworking engraving machine

    When it comes to woodworking engraving machines, many woodworking engraving manufacturers do not follow the operating principles and specifications when using this type of machine. Therefore, when the machine is used, the machine often fails, or the life of the machine becomes short and easily damaged. So, what is the correct way to operate this machine?
    1. Return to zero before use. When using the engraving machine, the woodworking engraving machine manufacturer reminds the operator that this is very important. Because if you don't return to zero, then all computer typesetting will deviate and invalidate.
    2. Note that the maximum time for continuous use should not exceed ten hours. Ten hours is the upper limit. Exceeding this time, the engraving machine is generally difficult to load, so pay attention to this.
    3. Adjust the speed of the knife. When using the engraving machine, adjust the rotation speed of the carving knife according to the hardness of the engraving wood. If the material is too hard, do not use high speed for a long time.
    4. After use, ask for cleaning. Many people will forget this point, but it is very important. After using the machine, clean it, especially the wood chips should be carefully cleaned, do not get stuck in the gap of the engraving machine, otherwise it will cause the machine to malfunction during the next use period. Or it can't be rotated, or the accuracy of the rotation is affected.

How to fix the problem of spindle noise in stone engraving machine?

   Since many stone engraving machines are now operated by electronic programs, they are much more convenient, so they are used more and more widely. However, such large-scale industrial electronic equipment, which has been in disrepair or used too frequently, will always have such small problems, especially in large enterprises and factories. Since the machines are all purchased in the same batch, sometimes problems are accompanied. In the aftermath, especially after a long time, the machine spindle always makes a strange sound, and the sound of each machine is different. What is the reason for this?
    The sound of the machine shaft is very common, because the surface waviness of the part has changed. It is recommended that professional repair workers check the bearing raceway surface and carefully re-run it. There are also some machines that make the sound of the motor turning, and it is getting louder and louder over time. It is recommended to add some lubricant and replace the shaft to solve the problem.
As long as it is a regular large-scale stone engraving machine manufacturer, it is operated by special personnel for after-sales and repair services, and there is still certain guarantee in repair costs. Therefore, it is necessary to do a good job of investigation before ordering, select a regular manufacturer, and the production process. In addition to not only follow the instructions and regulations, but also regular maintenance, daily personnel inspection is indispensable, can not wait until the problem is accumulated, then solve the problem, must delay the construction period.